Tank lashing strap set NL 30mm Wide for mounting LPG cylinder tank up to 100L

Lashing strap set NL 30mm Wide for mounting LPG cylinder tank up to 100L

Lashing strap set incl. mounting material for making 2 lashing straps (Tank straps). Suitable for Mounting LPG cylinder tanks up to 100L. The steel tank straps are provided with a plastic insulation.

Application: To be used in combination with a tank frame (tank rack) for installing an LPG cylinder tank (LPG vapor tank) with a tank diameter of at least 270mm and at most 400mm. Use the RDW installation requirements for a correct and safe installation.

TIP!: Provide the entire tank installation with a protective coating as soon as everything is properly fixed. This is particularly important in the case of substructures. This extends the life of the tank and construction. Preferably repeat this annually.

ADVICE: For substructures (where the lashing straps must bear the weight of the tank) and LPG cylinder tanks larger than 80L, we recommend mounting them using mounting rings and not using a tank frame and lashing straps.

For surface-mounted and LPG cylinder tanks larger than 140 L, we advise not to mount them using a tank frame and tension straps, but with the specially intended tank bracket set available for a tank diameter of 450 mm.

Assembly instructions:
The strap (tank strap) goes over the tank and the ends of the strap go through the strap and then back around the tank, but under the previously mentioned part of the strap that you just applied. The ends of the lashing straps therefore go through the lashing bracket and back under the same lashing strap with a minimum overlap of 15 cm (preferably more).

At the rear, the tension bracket is bolted to the tank frame. And at the front, the tension bracket with the bolt is fixed to the upright bracket on the tank frame, so that you can tension the tension strap by further tightening the bolt / nut. (See images for reference.)

No weakenings may be made in the lashing straps, for example by making a hole. The lashing straps may only be attached using the intended and supplied lashing brackets.

Number of straps: The LPG tank must be fixed to the tank frame with at least two tank straps. If the tank straps also bear the weight of the LPG tank, at least three tank straps must be fitted. However, we recommend using at least 4 lashing straps in that case. The tank straps are still sold per set (2 pieces). The exact number of tank bands to be used depends, among other things, on the tank capacity and the positioning of the LPG tank. Use and respect the RDW installation requirements for a correct installation.

Advice: Have the installation of the gas tank and the assembly of the tank frame done by an expert person or specialist company.