LPG Tank Installation Kit for Cyl. tanks Ø45cm 120L until 230L
Use this kit to mount your cylinder tank with a diameter of 45cm. The set comes standard with 2 fixation brackets, insulation foam, nuts and bolts, a filling connection, a filling hose, a breather hose and bottom breather and various mounting items.
TYPE : Rear set (Tank mounting material) for Cylinder tank or Vapor gas tank (cylinder)
Only suitable for LPG Cylinder tank diameter 450mm
Specify for which Type: Filling point, Filling adapters and Filling hose.
Choose your desired filling hose length: from 0.50m - 3.50m
Use this kit to mount your cylinder tank with a diameter of 45cm. The set comes standard with 2 fixation brackets, insulation foam, nuts and bolts, a filling connection, a filling hose, a breather hose and bottom breather and various mounting items.
TYPE : Rear set (Tank mounting material) for Cylinder tank or Vapor gas tank (cylinder)
Only suitable for LPG Cylinder tank diameter 450mm
Specify for which Type: Filling point, Filling adapters and Filling hose.
Choose your desired filling hose length: from 0.50m - 3.50m
Product customization
Don't forget to save your customization to be able to add to cartForeign companies with a valid VAT number shop VAT-free here! READ HOW.
Safe & TrustedWebshop Trustmark Certified Member & Secured by SSL. Your data and orders are safe here.
Delivery policySafe and Secure Shipping with DPD or DHL
Refund policyPolítica de reembolso de 14 días y derecho de devolución
You can order this tank mounting set in combination with a matching LPG cylinder tank Ø45cm for mounting your LPG tank (120L - 230L). (For Smaller cylinder tanks see the smaller associated tank mounting sets)
Set content:
- 2 x Tank Brackets + insulation foam (Suitable for Cyl. with a diamter of 450mm.)
- 1 x Filling connection (type of your choice. See options)
- 1 x Filling hose (Desired filling hose length optionsl)
- Filling hose clamps for fixing your filling hose
- Mounting material Bolts, nuts, self-tapping screws, hose clamps
- 1 x Ventilation hose To be connected to the tank box of the LPG tank (LPG built-in)
- 1 x Bottom air vent To connect the vent hose and to be able to carry the gases out through the bottom.
Attach the mounting brackets with the base to a strong and sturdy part of the vehicle with a sufficient number and strength of bolts.
The gas tank must not make metallic contact with the tank brackets. Therefore, install insulation in the tank brackets so that the tank cannot make metal-to-metal contact with the brackets. Adhesive foam insulation is included. Apply this to the inside of the mounting brackets.
Bend the mounting brackets slightly open to be able to insert the gas tank.
Determine the position of the gas tank carefully. Pay close attention to the marking (cross with arrow) on the gas tank for correct positioning for proper functioning of the gas tank. The mark indicates the top and the horizontal center plane. And also pay close attention to the position of the flanges of the brackets in relation to the tank fittings (tank cabinet), so that the incoming and outgoing pipes are not blocked. Use a sufficient number of bolts of the correct quality for a sufficiently strong construction.
No weakenings may be made in the mounting brackets, for example by making a hole. Use and respect the national installation requirements / NPR-2577 guidelines for correct installation. (see the attachments tab on this page)
Insulation A steel (or aluminum) LPG tank may not make metallic contact with the mounting brackets. It is therefore necessary to apply an insulating layer between the tank and the brackets. You can use the supplied adhesive foam for this.
Data sheet
CONTACT FORM
