LPG Gas hose Ø16mm x 24mm Rubber R67-01 - Per meter | +€8.40 |
- -40%
PLEASE NOTE! For gas hose with internal size 16mm ("DN16" or "ID=16" on gas hose)
Foreign companies with a valid VAT number shop VAT-free here! READ HOW.
Webshop Trustmark Certified Member & Secured by SSL. Your data and orders are safe here.
Safe and Secure Shipping with DPD or DHL
Política de reembolso de 14 días y derecho de devolución
High quality filter element inside.
Approval: E20 67R-010906
Housing: Ø46 mm - length 54mm
Total length: 100mm
Connections in- and outlet: Ø16 mm (for Gas hose with an internal diameter of 16mm)
NOTE: This type of filter (F-781) is available for 4 different gas hose diameters / sizes; 10/12/14 /16mm.
Make sure you order the right size!
For re-orders: The size of the filter is printed in miniature on the filter.
It concerns the inner diameter of the gas hose (= diameter connection to filter). The diameter of the gas hose is also indicated on the gas hose for identification with, for example, "DN12" or "ID = 12"
DN12 = 12mm - DN14 = 14mm - DN16 = 16mm
Replace the gas filter in time and regularly!
The filter lasts a maximum of 20,000 km. Preferably replace the filter earlier.
This replacement period applies with an average engine capacity of approximately 1.8L. Larger engines use more gas, which means the gas filter needs to be replaced sooner.
It is also possible that the LPG contains a lot of contamination (with oil and fats) at some refueling, which means that it is necessary to replace the filter earlier. Take this into account.
The timely replacement of the gas filter is necessary to prevent contamination of the gas system and gas injectors.
TIP!
Use 2 filters one after the other (in series) instead of just 1 filter. This allows you to prevent the contamination of the injectors even more when driving on a polluted LPG quality, for example. In this way there is a second filter that can still catch the excess paraffin.
In most cases the problem is caused by the fact that the injectors are contaminated with paraffin (oils and greases from the LPG). The filter in front of the injectors must ensure that the injectors do not contaminate quickly. This filter will eventually become saturated and must be replaced every 20,000 km. If the filter is not replaced, the paraffin will no longer be trapped and end up in the injectors. It is not the case that the injectors leak or do not open anymore. But the opening and closing time are no longer correct. The injectors remain open longer than they should (with dynamic behavior), which means that too much fuel is being dosed. (too rich mixture) The injectors will then deviate, especially with short injection times (low engine load). The engine is going to run messy and there are too large differences between the injectors. Cleaning the injectors often makes no sense, because there is often too much wear in the injector occurred, as a result of which the guide of the plunger (sealing disk) no longer has the right fit. The plunger does not go smoothly and lord, but goes up and down stumbling and wobbling. If the injectors are replaced without replacing the filter, the new injectors will soon become dirty again. (read symptom control, no long-term solution)
Data sheet